Steell Casting Body Eccentric Press;
Considering the possible risks which the pig-casting may cause, the body ofour 10 and 20 tons eccentric presses are made of steel casting.
Quality material - Qualitied workmanship
Our presses are combined with the top quality material, qualitied workmanship and esthetics.
Made of special alloyed bronze material resistant to high cycles and stroke.
Clutch cotter is made in two pieces to provide a convenience in changing.
In order to provide an endurance against the over-stokes exceeding the press power and material weariness, the crankshaft eccentric is made filled. Thus, the critical cross-section diameter is provided to be maximum and the critical cross-section number to be minimum.
In order to prevent the hazards which may occur in case of leaving the clutch system continually open, the single-stroke safety system in fixed.
Guaranteed two years against the material and workmanship defects.Use faults are exempted from the guaranty.
The malfunctions, which may occur within the guarantee period and in the following years are solved by our service specialists as soon as possible.
|Capacity||unit||10 ton||20 ton|
|Adjusting of stroke||mm||5-35||5-60|
|Number of hits of stroke||a/d||180||135|
|Knob Shaft Max Operating Range||mm||30||35|
|Hole diameter of the table||mm||90||100|
|Between table central and body||mm||200||240|
|Between table and head||mm||160||180|
|Between adding table and head||mm||90x150||125x260|
|Crank Shaft Stopping Point||Top dead point|
|Height of Press||mm||1400||1650|
|Depth of Press||mm||650||850|
|Width of Press||mm||600||800|
|Power of engine||hp||1,5||2|
|Structure of Body||Steel Casting|