Steel Construction Eccentric Press;
The body of our 30-40-60-80-130-200 tons presses are manufactured as steel construction and supported with necesary resistance as per its pressing power.
Quality material - Qualitied workmanship
Our presses are combined with the top quality material, qualitied workmanship and esthetics.
Parallelism and set square
Head rear slide can also be adjustable like front slides.Thanks to this, nonregulation, which may occur between the head and table as time passes, is casily cradicated.
In order to provide a practical and easy-lubrication, a manual double-hand controlled electro-pneumatic system is installed.
Made of special alloyed bronze material resistant to high cycles and stroke.
Clutch cotter is made in two pieces to provide a convenience in changing.
In order to provide an endurance against the over-stokes exceeding the press power and material weariness, the crankshaft eccentric is made filled. Thus, the critical cross-section diameter is provided to be maximum and the critical cross-section number to be minimum.
In order to prevent the hazards which may occur in case of leaving the clutch system continually open, the single-stroke safety system in fixed.
A fuse system is installed for the purpose of decreasing the possible damages to minimum when exceeding over the press capacity.
Guaranteed two years against the material and workmanship defects.Use faults are exempted from the guaranty.
The malfunctions which may occur within the guarantee period and in the following years are solved by our service specialists as soon as possible.
|Capacity||unit||40 ton||60 ton||80 ton||130 ton||200 ton|
|Adjusting of Stroke||mm||10-70||10-85||10-90||10-110||10-140|
|Number of hits of Stroke||a/d||72||60||56||53||44|
|Knob Shaft Max Operating Range||mm||55||60||75||90||100|
|Hole diameter of the Table||mm||140||160||170||200||250|
|Between table central and body||mm||210||250||270||300||395|
|Between table and head||mm||280||320||360||460||560|
|Between adding table and head||mm||220||230||270||360||440|
|Pressure of clutch||bar||6||6||6||6||6|
|Connectable Top Mould size||mm||190x350||210x380||230x410||250x450||280x520|
|Crank Shaft Stopping Point||Top dead point|
|System of fuse||Mechanical disc|
|System of lubricate||Manual pump|
|Height of press||mm||1900||2050||2200||2450||2800|
|Depth of press||mm||1100||1350||1500||1800||2500|
|Width of press||mm||1000||1200||1250||1400||1700|
|Power of engine||hp||4||5,5||7,5||10||15|
|Structure of body||Steel construction|